9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (2023)

sunrise specialty»9 Easy Steps to Remove a Sink Stopper (with Pictures)

Most people are familiar with the experience of a clogged sink. At first the water takes a little longer to drain, but after a while even longer and sometimes it doesn't drain at all.

If this happens to you, the only solution may be to remove the cap to clear the drain pipe. The good news though is that this is an easy job anyone can do with just a few simple tools, and if you must give it a try, here's how to remove a sink stopper.

If you're looking for a preview of what we're about to talk about, you can also check out this video before reading any further.

Tools needed to remove the sink cover

before tryingRemove the plug from the sink., you need to assemble some basic elements. Here is the list of what you need.

  • wrench or pliersDepending on how tight the nut is, you may need a wrench or pliers to loosen it.
  • Lantern -A regular flashlight can come in handy, otherwise you may not be able to see what you're doing under the sink.
  • Brush (for example, old toothbrush) –It is not necessary to remove the sink cover, but it can be useful if you want to clean the sink.
  • regular detergent -A little regular bathroom soap is also helpful when you want to clean the stopper.
  • Vinegar -Vinegar can be helpful in cleaning the cork, though it's not necessary if you don't have one handy.
  • Bucket -A regular cube. This is useful if a sink leaks when you unscrew the nut.
  • Hair Clog Removal Tool -Once you've removed the stopper, you can use a depilatory tool to remove the hair and dirt that is blocking the sink. These are inexpensive tools that come in the form of a long piece of plastic with a hook to pull hair out of the sink.
  • drain cleanerAgain, it is not necessary to remove the cork, but once the cork and all the dirt is out, it is a good opportunity to clean the inside of the sewer pipe before putting everything back together.

How do I remove a sink stopper?

Once you have all the tools set up and ready, here are the steps you need to followRemove the plug from the sink..

Step 1. Try to remove the tampa manually

Some corks can be removed manually without the need for special tools or techniques. Just try to lift and twist the cork. That might be all you need to get it done.

Step 2. Remove items under the sink

If you can't get the cork out, you'll have to get under the sink to get it out, so the next step is to get whatever's stored under the sink out.Restroom sinkso that you have enough space to work.

Pro Tip:Be sure to remove everything under the sink before starting work. You may think this will take longer, but it is much easier to work with if you have enough leeway.

Step 3. Locate the horizontal piston rod

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (1)

Grab your flashlight and stick your head under the sink. You need to find the horizontal bar that connects the cork to the handle. It should be easy to spot - it's a bar attached to the vertical brace, the piece of metal with the holes.

Step 4. Locate the clip that holds the bar and the handle

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (2)

When you find the post and the metal loop it attaches to, you'll see that they are attached by a small metal clip.

Remove this clip so the bar and handle are no longer connected and place the clip in a safe place to avoid losing it.

Pro Tip:Note which hole in the handle the rod fits into before removing the clip. So you'll know how to put it back together. If you think you can forget it, use your phone to take a photo.

Step 5. Loosen the pivot nut

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (3)

The other end of the rod that you just separated from the handle should be attached to a swivel nut and now you need to unscrew it.

At this point, it's a good idea to place a bucket under the sink to catch any water that spills from loosening the nut.

With the bucket in place, try to loosen the nut by hand. If it does not come out, you will need to use the pliers or wrench to loosen it.

Pro Tip:When you loosen the nut, be prepared for some water leakage, especially when the drain pipe is clogged. It will probably be quite dirty, so try not to get it on your face!

Step 6. Remove the cover

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (4)

The stopper should now be free so that you can remove it from the sink by hand.

Pro Tip:If your sink was clogged, chances are the stopper is covered in gunk and pretty gross. However, once you're outside, this is a great opportunity to give it a deep clean. Remove as much dirt as possible with your hands and continue cleaning with a small brush.

While you're away, you may even decide to keep cleaning it, so use dish soap and vinegar along with some warm water to clean it.absorberbefore resetting it.

Step 7. Remove hair with the epilator

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (5)

Before replacing the cork, take the opportunity to remove hair and slime from the hole. Use the waxing tool for this; You should have no problem removing most of the clogged hair and other gum from the sink.

Step 8. Consider washing it down with a drain cleaner

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (6)

Before reinserting the plug, this is a good opportunity to thoroughly clean the drain tube, especially if it was severely clogged previously.

Follow the instructions on your drain cleaner, pour it down the drain, and let it work. After it's been in there long enough, usually at least ten minutes, rinse it under hot water in the sink.

The water should flow easily, which means that you have successfully cleared the clogged drain.

Step 9. Put everything in its place

9 Easy Steps to Remove a Sink Plug (with Pictures) - wikiHow (7)

After you've cleaned everything up and cleared the drain, it's time to put everything back to the way it was. Just follow the same steps in reverse order.

First put the sink cover back in the hole. Then go under the sink and screw the nut back on and retighten it with the wrench or pliers as needed.

Once the nut is tight, reattach the bar to the handle using the clip you removed earlier. Once this is done, get out from under the sink to test the cork.

If it moves up and down normally when you push and pull the spirit level, you have successfully reinserted it. Finally, put everything back under the sink, dry everything with a cloth, voila!

additional pro tips

Here are some additional tips to help you succeed in this job.

Find matching parts when you need to replace them

If you're replacing engine parts instead of the whole thing, make sure you find parts that are an exact match. You can remove the old parts and take them to the hardware store to make sure you find the exact parts you need.

Prepare a tray to keep the pieces safe while you work.

With this type of work, it's easy to lose the small parts you're removing. So it's good to have a bowl or tray ready to put the pieces in so they don't get lost or fall down the sink.

use luvas drunk

Sinks get clogged with masses of tangled hair and all manner of dirt, and getting it all out can be quite awkward. If you don't want to touch it with your bare hands, it might be a good idea to wear a pair of rubber gloves while you work.

Act sooner rather than later

If you notice your sink draining more slowly, it's only natural to wait and hope it will work itself out. However, this rarely happens, and when a sink drains slowly, the problem will only get worse until you do something about it.

That means it's better to act sooner rather than later, because quitting makes the job harder and more uncomfortable once you start taking care of it.

A simple operation that can save you some money.

Calling a plumber is expensive, regardless of the work they need to do. Fortunately, many jobs are easy to do yourself, and with this guide, removing a sink stopper should now firmly fall into that category.

More about Sunrise's specialty:

  • Wet room: everything you need to know!
  • How do I paint a bathroom? (step by step instructions)
  • 27 simple ideas to store bathroom towels
  • 28 bead board bathroom design ideas
  • Why don't the toilets go all the way to the floor and ceiling?
Top Articles
Latest Posts
Article information

Author: Roderick King

Last Updated: 01/18/2023

Views: 6447

Rating: 4 / 5 (51 voted)

Reviews: 82% of readers found this page helpful

Author information

Name: Roderick King

Birthday: 1997-10-09

Address: 3782 Madge Knoll, East Dudley, MA 63913

Phone: +2521695290067

Job: Customer Sales Coordinator

Hobby: Gunsmithing, Embroidery, Parkour, Kitesurfing, Rock climbing, Sand art, Beekeeping

Introduction: My name is Roderick King, I am a cute, splendid, excited, perfect, gentle, funny, vivacious person who loves writing and wants to share my knowledge and understanding with you.